| This Event |
Is Fired
When |
|
| AcquireDone |
...any
Acquire- method completes successfully. |
1.32 |
| ActiveImageChanged |
...the current (active) image changes appearance or properties. |
1.32? |
| Click |
...the
user clicks on the EZTwainX control, either right- or left-click. |
1.32 |
| Error(scode,
sDescription, uHelpID) |
...the
control detects an error. These are conventional errors like
bad parameter values, file I/O errors, and so on. Problems when
negotiating with a TWAIN device are signaled with a different
event. |
1.32 |
| PageCount(n) |
...the value of the PageCount property changes. Replaced
by PageCountChanged in 1.43 |
1.32-1.42 |
| PageCountChanged(n) |
...the value of the PageCount property changes. n is (new) number
of pages stored by the control. Note: In certain cases this
will be fired when the value 'could have' changed, even though
the actual value did not change. Note: When loading a multipage
file or scanning multiple pages this event is fired after each
new page is added. |
1.43 |
| PageIndex(i) |
...the
PageIndex property changes. Replaced by PageIndexChanged
in 1.43 |
1.32-1.42 |
| PageIndexChanged(i) |
...the
PageIndex property changes. |
1.43 |
RectangleSelected
(x,y,w,h) |
...the user finishes selecting a rectangle using the Rectangle Selection tool. The top-left corner of the selection is at (x,y) and it is w pixels wide and h pixels high. Coordinates are in pixels where (0,0) is top-left corner. |
1.51 |
| ZoomChanged |
...the ZoomFactor property changes. |
1.44 |
Overview 
